MAIN USES: Suitable for interior and exterior all metal,wood, plaster, brick and concrete surfaces.
COLOR RANGE: Please refer to standard Color Card.
COVERING CAPACITY: 14 – 17 m2 / Litre per coat
DRYING TIME: Surface Dry: 3hours, Hard Dry: 24hours, Recoat able: 12-18hours (Depending on the Humidity & Temperature)
PACKING: 3.64 Litres, 0.91 Litres
Preparation of the surface is the most important step in painting and greatly affects the life and appearance of paint. MOBI Synthetic Metallic Enamel should be applied following the priming. For smoothing out rough surfaces or where the color of finish as changed appreciably,use of undercoat is recommended. For maximum durability,apply MOBI Synthetic Metallic Enamel Paint directly to primer. Previously unpainted surfaces must be thoroughly cleaned before painting. Rust, Mill Scale,Oil, Dust and Grease may be removed by wire brushing,abrasive paper or white spirit. Old work, in a bad condition (blistered,flaked ,cracked ,or powdery )must be burnt off or stripped with paint remover. After cleaning apply one coat of MOBI Undercoat and on drying apply two coats of MOBI Synthetic Matallic Paint. For wood all knots and resinous patches should be treated. In case of bright and new metal surfaces such as Galvanized Iron or Aluminum rub it down with fine sandpaper and clean with white spirit so th at paint may not flake off.
TIPS FOR SAFETY, ECONOMY AND ENVIRONMENTAL PROTECTION
Keep the paint away from sources of ignition and avoid smoking. Where the painting is in progress ensure adequate ventilation. Do not breathe vapours,use of suitable respiratory equipment is highly recommended. Keep paint container air tight after use and store in a shady & dry place. To save the unused paint for longer period of time,replace the lid firmly and invert the can for few seconds to seal the lid. It will help to prevent skinning. Rinse with plenty of water in case of eye contact and seek medical advice. Use white spirit,turpentine oil or skin cleanser to remove splashes from skin. Scrape excess paint out of brushes and rollers before cleaning. Wash all equi pment immediately after use with white spirit or turpentine oil. Shake excess liquid out after washing and then wrap them in a piece of clean cloth. Doing so will revive your brushes back to original. Do not dispose-off excess paint or paint waste into drains or watercourses, disposal should be done in accordance with the environmental regulations.