
Mobi CR Road Line Marking
Mobi CR road line marking is single pack fast drying coating based on a durable alkyd modified chlorinated rubber base resin. It may be applied to concrete and bitumen surfaces without bleeding or discoloration, providing clean lines of high visibility. It is recommended for making roadways, car parks and pavements.
₨ 2,900 – ₨ 17,800Price range: ₨ 2,900 through ₨ 17,800
PRODUCT INFORMATION
No color shades found for this product.
SURFACE PREPARATION:
Surfaces must be free from dust, dirt, grease, oil, heavy shoot or chalk. Remove all defective or poorly adhering
materials by rubbing down using a suitable abrasive paper or stiff brush.
Metal Surface:
After priming new surfaces with MOBI Red Oxide Primer or Wash primer for nonferrous surface, fill the surface where required with Steel Putty. Please refer to TDS of Mobi Red Oxide Primer for correct application procedure and drying time properties.
Wooden Surface:
Scuff of the surface with suitable abrasive paper than prime the surface with MOBI Undercoat White and then fill any surface imperfections with Putty. Scuff the surface using suitable abrasive paper and dust off.
TECHNICAL DATA | |
---|---|
Composition (Nominal) | |
Pigment | Non Lead Pigment |
Binder | Alkyd |
Solvent | MTT, Kerosene Oil, White Spirit |
Volume solids | 50 ± 10 % |
Colors | All Colors from shade card. |
Film Thickness | Dry : 35 ± 5 microns. |
Pack Viscosity | 18 – 22 Poise |
Specific Gravity | 1.36 ± 0.1 Depending upon colors |
Gloss | Maximum 10 Gu |
Drying Time at 25°C | 5–6 Hours |
Recoat at 25°C | 16 Hours |
Practical Coverage | A guide to the practical coverage which can be achieved under normal condition is 140–170 Square foot /liter/coat. |