Description

MAIN USES:                         Suitable for interior and exterior all metal,wood, plaster, brick,asbestos and concrete surfaces.
COLOR RANGE:                  Please refer to standard Color Card.
COVERING CAPACITY:     14-17 m2 / Litre per coat
DRYING TIME:                    Surface Dry: 3hours, Hard Dry: 24 hours, Recoat able: 12-18 hours (Depending on the Humidity & Temperature)
PACKING:                             3 hours,  24 hours,  12-18 hours

SURFACE PREPARATION
Preparation of the surface is the most important step in painting and greatly affects the life and appearance of paint. MOBI Synthetic Enamel should be applied following the priming. For smoothing out rough surfaces or where the color of finish has changed appreciably, use of undercoat is recommended. For maximum durability,apply MOBI Synthetic Enamel directly to primer. Previously unpainted surfaces must be thoroughly cleaned before painting. Rust, Mill Scale, Oil,Dust and Grease may be removed by wire brushing,abrasive paper or white spirit. Old work, in its bad condition (blistered, flaked, cracked, or powdery) must be burnt off or stripped with paint remover. After cleaning apply one coat of MOBI Undercoat and on drying apply two coats of MOBI Synthetic Enamel. For wood all knots and resinous patches should be treated. In case of bright and new metal surfaces such as Galvanized Iron or Aluminum rub it down with fine sandpaper and clean with white spirit so that paint may not flake off.

PRIMING
It is often necessary to apply an appropriate “primer” as first coat. All primers should be applied by brush for building surfaces,since spray applied primers do not penetrate or stick to rough or porous surfaces well. Priming coats must be left overnight for hard drying under normal weather conditions. For priming, appropriate MOBI undercoats are available for each type of surface.

APPLICATION
Please stir thoroughly before applying to ensure even pigmentation. Thin it down with good quality white spirit to desired application viscosity for brushing & spray application. Apply two coats of MOBI High Gloss Synthetic Enamel for best results. Allow 12 to 18 hours between coats under normal weather conditions.

TIPS FOR SAFETY, ECONOMY AND ENVIRONMENTAL PROTECTION
Keep the paint away from sources of ignition and avoid smoking. Where the painting is in progress ensure adequate ventilation. Do not breathe vapours,use of suitable respiratory equipment is highly recommended. Keep paint container air tight after use and store in a shady & dry place. To save the unused paint for longer period of time,replace the lid firmly and invert the can for few seconds to seal the lid. It will help to prevent skinning. Rinse with plenty of water in case of eye contact and seek medical advice. Use white spirit,turpentine oil or skin cleanser to remove splashes from skin. Scrape excess paint out of brushes and rollers before cleaning. Wash all equipment immediately after use with white spirit or turpentine oil. Shake excess liquid out after washing and then wrap them in a piece of clean cloth. Doing so will revive your brushes back to original. Do not dispose-off excess paint or paint waste into drains or watercourses, disposal should be done in accordance with the environmental regulations.